Product directory

Home > Q510/Q510A

Product Introduction:
3 Way Dual 10 Inch Line Array Speaker
  • features


    The speaker uses a passive three-way design with two 10" low frequency

    units, one 8" IF unit with horn, and two 1 .4" high frequency compression

    units (2" voice coi l mounted on the ring waveguide) . Due to the symmetrical

    dipole arrangement of the low frequency unit of the neodymium magnet and

    the intermediate frequency unit and the high frequency unit of the coaxial

    structure, the adjacent frequency bands are smoothly superimposed by the

    cross-coupl ing design; this can make the excel lent 80° horizontal constant

    pointing angle control Lower frequency limit to 250 Hz. The mechanical component

    structure and acoustic design al low for the erection of up to 24 vertical l ine

    arrays. It can be composed of a separate line array system or a system with

    multiple SUB speakers. The cabinet is made of nautical wooden plywood and

    the surface is treated with anti-col l ision paint and open-air protective paint

    (Polyurea Cabinet Protection). The front panel of the speaker is protected by a

    hard metal mesh cover with a sound-permeable foam. The side panels are equipped

    with handles and two additional built-in handles are provided at the bottom of the

    rear of the cabinet.


    Model Q510 Q510A
    Frequency response 150Hz-20KHz 42Hz-250Hz
    Driver LF:10"×2 18"×1 front
    MF:8"×1 12"×1 rear
    Nomina limpedance 16 Ohms 16 Ohms
    System sensitivity 95dB 95dB
    Rated power LF:600w 600w front
    MF:200W 400w rear
    Peak power LF:1200w 2400w front
    MF:400W 1600w rear
    Maximum SPL 127dB 127dB
    Disperion  Angle horizon:80° ,verticality:10° /
    Crossover  mode External Crossover External Crossover
    Suspension Linear  suspension Linear  suspension
    Net weight 35KG 66.6KG
    Size(mm) 710W×430D×230H 550W×750D×426H
    Package size(mm) 810W×530D×330H(flight case ) 660W×850D×526H(flight case )

  • Comment

DM20new version update step


1) Copy the compressed package to the USB flash drive (note that you don't need to decompress it, it is best to format the USB flash drive first)


2) Insert the USB flash drive into any USB port of the mixer, and click “SETUP” on the mixer panel → “Maintenance” → “Update from USB” in the screen


Follow the prompts to complete the installation steps.

Disclaimer: There are pictures in the text from the network, if there are copyright issues, please contact the author to delete!     
Go Back